Logo

B3000 Engine Trouble Code

Meaning of B3000 engine trouble code is : Theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $200-$300 depending on the car, but that's usually the cost of parts because the labor is relatively simple.

B3000 Possible Solution:

B3000 Engine

Power Steering Pressure (PSP) Switch Malfunction In Key On, Engine Off Self-Test, this DTC indicates the PSP input to the PCM is high. In Key On, Engine Running Self-Test, this DTC indicates that the PSP input did not change state. Steering wheel must be turned during Key On, Engine Running Self-Test PSP switch/shorting bar damaged SIG RTN circuit open PSP circuit open or shorted to SIGRTN PCM damaged.

B3000 Code Meaning :

B 3 0 0 0
OBD-II Diagnostic Body (B) Trouble Code For Engine Ignition System Or Misfire Ambient Air Temperature Sensor Circuit Low Cold Start Injector 1 Malfunction Shift Solenoid E Performance or Stuck Off

The poor running symptoms are consistent with a MAP sensor malfunction. In addition, in some cases, a bad MAP sensor will not throw a code. Again, the ELD code likely represents a separate wiring issue.

B3000 OBD-II Diagnostic Body (B) Trouble Code Description

B3000 engine trouble code is about Shift Solenoid E Performance or Stuck Off.

Reason For B3000 Code

The reason of B3000 OBD-II Engine Trouble Code is Ambient Air Temperature Sensor Circuit Low.

B3000 DTC specifically refers to the camshaft (cam) timing. In this case, if the cam timing is over-retarded, the engine light will be illluminated and the code will be set.